Panels

Question How do I configure downstream devices not connected to port 2 when I promote my access panel to an LNL-2220 or LNL-3300 in System Administration? Answer When promoting an LNL-500, LNL-1000, or LNL-2000 access panel to an LNL-2220 or...

How to configure automatic encryption for the LNL-500/1000/2000 controller Procedure Steps The controller must have a 256 KB chip in order to utilize encryption. 1) In System Administration, on the System Options > Controller Encryption tab, c...

How to run a debug on a Bosch (Radionics) panel Procedure Steps 1) Click Start, then select Run . 2) Type ACS.INI and click [OK]. 3) Add the following to the ACS.INI file under the [Service] section: [Radionics] DebugFile=1 4) Save the...

Symptom You may be unable to upgrade the firmware for an LNL-2220 to version 1.046 from any previous firmware revision. The normal steps taken to download firmware appear to work successfully, but the firmware revision does not change in Alarm M...

How to uninstall and reinstall ScanShell software Procedure Steps If you have attempted to install and configure a ScanShell 800 or 1000 device and the device is not functioning properly, follow the steps below to uninstall and reinstall the de...

How to set the jumper for reader power on the LNL-2220 and Series 2 LNL-1320 Procedure Steps When setting Jumper J7 on the LNL-2220 or J2 on the LNL-1320 board, always use "PT" for any system with 12 VDC power supplies. Only use the "12V" sett...

How to configure Black Box IC108A for 2-wire ISC communication Procedure Steps 1) To wire the Black Box IC108A for 2-wire communication: - Connect TxA and RxA with a jumper. - Connect TxB and RxB with a jumper. - Connect TxA on the IC108A to...

How to address devices connected to the LNL-8000 Procedure Steps Configuration of the device address is done in System Administration. 1) Configure the port for the device. This is the port number on the ISC that the LNL-8000 is connected to...

Symptom Certain drop-down lists inside the LNL-3300 and LNL-2220 Configuration Web Page are blank or unpopulated. Therefore, you are unable to make a selection from the drop-down list. Note: This does not apply to the LNL-1000, LNL-2000, an...

Symptom A "No Tamper Signal" event is displayed in Alarm Monitoring for the LNL-2020W. Resolution Verify that the correct keypad has been selected on the Reader tab in System Administration. It should be configured as LNL-2020W with tamper, ...