Panels

Problem Overview New Zone Faulted Status Not Handled for Galaxy Dimension Panels (OG-20304) Detailed Description The new Dimension Zone Faulted status is not supported by OnGuard 2010. Applies To OnGuard 2010 (6.4.xxx) Additional Inform...

Question How do I transfer the warranty and ownership of a Dell product from one owner to another owner? Answer For transfer of warranty and ownership in the United States , navigate to the site below: https://support.dell.com/support/topi...

Product Name HID iCLASS Card Compatibility with HID iCLASS Programmers and Encoders General Information There are three types of HID iCLASS cards that can be sourced from Lenel: 1) Configured and programmed iCLASS cards (HID Part Number 2...

How to connect and initially configure an LNL-2220 or LNL-3300 access panel via the Web configuration page Procedure Steps 1) Configure the computer IP address in the range of 192.168.0.2 to 192.168.0.254, except for 192.168.0.251 as this addr...

How to update firmware for a Lenel access panel Procedure Steps Complete the following steps to replace firmware files and update the firmware for all currently supported Lenel access panels: 1) Obtain the correct revision of the firmware for ...

How to replace firmware files for Lenel Reader Interface Modules (RIMs) in an OnGuard installation Procedure Steps Complete the following steps to replace firmware files and update firmware for all currently supported Lenel reader interface mod...

How to change reader LED behavior Procedure Steps Overview   The reader LED settings can be configured in the ACS.INI file and can only be done for all readers on Lenel panels under the same Communication Server (that is, you cannot do ...

How to troubleshoot a Lantronix device Procedure Steps 1) Make sure the device can be pinged by IP address by running the following command: ping If the device can be pinged, continue to the next step. If the device cannot be pinged, make ...

Question How should the modem status LEDs appear for both host and panel modems? Answer Status LEDs for both U.S. Robotics and SECURCOMM DC336 modems are indicated below. Information for both the host and panel-end modems is listed for each...

How to determine the firmware version of USRobotics 56K V.92 external modems Procedure Steps Obtaining the firmware version requires a HyperTerminal session on the server side. 1) Click the Start button, and then select All Programs > Acces...