How to setup a failover on an LNL-3300 with a Cobox / Lantronix Device
Procedure Steps
- Use the CoBox parameters provided in the Hardware Installation Guide (Configuring a CoBox Micro 100 Using Telnet). Set 38400 as the baud rate, etc. in the interface.
- Verify you can ping the IP address and Telnet over the communication port on the Cobox / Lantronix device.
- Access Panel configuration in OnGuard: Set the Primary Connection and Secondary Connection to IPv4 with the correct IP address and port for both the Primary Connection and the CoBox.
- LNL-3300 IP configuration **(commonly missed): On the Host Comm page, set Alternate Host Port to Serial-Adapter with a baud rate that matches the Cobox (38400).
- Click [Accept], and then click [Apply Settings].
- Alarm Monitoring will show the panel online and the secondary connection when it is failed over.
Applies To
LNL-3300
Cobox
Additional Information
None
